Just a thought. I'm not certain what diameters and what tolerances are required.
Printable View
Just a thought. I'm not certain what diameters and what tolerances are required.
I got some 90-duro urethane in today, I don't think that is what Palmers use, this stuff is pretty flimsy.
I have a small sheet of their material from when i worked there, it has their small reg seals cut in it (it was done with the laser cutter/laser engraver at that time)
I have tried to get Craig to give up what it is but i have not had any luck....it may be 90 duro it could also be harder, 110 maybe? I really should find someplace to send it to so they can analyze it and figure out what the hell it actually is, heh.
damn industry secrets, lol
I went ahead and used the duro90, haven't tested them yet but I don't see why they wont work. :)
http://i550.photobucket.com/albums/i...ps9ee53f4f.jpg
interested in results for sure....
Getting close to finishing the project, here are the regulators>>
http://i550.photobucket.com/albums/i...ps47ba4f54.jpg
They are sleeper Foregrip LPR's for Pneumags.
http://i550.photobucket.com/albums/i...psab9c6c96.jpg
that is disturbingly hot.
Well... this looks promising.
Pre order from here. http://www.automags.org/forums/showt...7-LPR-Foregrip
Wink, wink, nudge, nudge. ;)
Oooooo...interesting, If I liked mags I would be all over that....