Results 1 to 9 of 9

Thread: warpless z2

  1. #1
    Junior Member
    Join Date
    Jul 2013
    Location
    Chester nh
    Posts
    11

    warpless z2

    Ok so I was bored and decided I should hack up a loader :what:


    Damn compared to the halo line the z2 has no room for this. Cut down the elbow and had to thin it down a little more than half of the material to get it to sit in the existing Raceway as I wanted to cut the z2 as little as possible.


    Had to notch the battery block to get it to fit will look into other power options later


    Almost there!





    Now I just need paint to test run in. Notice the motor is the same size as a halo one so might get some high torque motors depending on how the stock one holds up.

    https://www.youtube.com/watch?v=IWhQ...e_gdata_player

  2. #2

  3. #3
    Junior Member
    Join Date
    Jul 2013
    Location
    Chester nh
    Posts
    11
    240 shells


  4. #4

  5. #5
    Junior Member
    Join Date
    Jul 2013
    Location
    Chester nh
    Posts
    11
    Just put it on this morning so haven't gotten it out on the field yet but I don't think it would take to much out of the capacity.

  6. #6
    Junior Member
    Join Date
    Jul 2013
    Location
    Chester nh
    Posts
    11
    On the z2 board is there a way to turn off the automatic un-jam feature?

  7. #7

  8. #8
    Junior Member
    Join Date
    Jul 2013
    Location
    Chester nh
    Posts
    11
    Yeah I just did that and swapped the motor for a hi torque motor i vehicle use on my halo too. I noticed a drop in the feed rate and I think the anti jam burned out the stock one

  9. #9
    The Prophecy board uses feedback from the motor current to control it. Swapping out the motor have have caused the issue. It wouldn't be sensing it correctly.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •