Page 2 of 3 FirstFirst 123 LastLast
Results 11 to 20 of 21

Thread: Low pressure regulator valve seals

  1. #11
    Insider new ion?'s Avatar
    Join Date
    Feb 2013
    Location
    Victoria, BC
    Posts
    1,296
    Just a thought. I'm not certain what diameters and what tolerances are required.

  2. #12
    Insider
    Join Date
    Jun 2012
    Posts
    134
    I got some 90-duro urethane in today, I don't think that is what Palmers use, this stuff is pretty flimsy.

  3. #13
    Insider FirePro84's Avatar
    Join Date
    May 2012
    Location
    Vacaville, CA
    Posts
    544
    Supports Inception Designs
    I have a small sheet of their material from when i worked there, it has their small reg seals cut in it (it was done with the laser cutter/laser engraver at that time)

    I have tried to get Craig to give up what it is but i have not had any luck....it may be 90 duro it could also be harder, 110 maybe? I really should find someplace to send it to so they can analyze it and figure out what the hell it actually is, heh.

    damn industry secrets, lol

  4. #14
    Insider
    Join Date
    Jun 2012
    Posts
    134
    I went ahead and used the duro90, haven't tested them yet but I don't see why they wont work.


  5. #15
    Insider FirePro84's Avatar
    Join Date
    May 2012
    Location
    Vacaville, CA
    Posts
    544
    Supports Inception Designs
    interested in results for sure....

  6. #16
    Insider
    Join Date
    Jun 2012
    Posts
    134
    Getting close to finishing the project, here are the regulators>>


    They are sleeper Foregrip LPR's for Pneumags.


  7. #17
    Insider TierOneJeff's Avatar
    Join Date
    Jul 2013
    Location
    Toronto, Ontario
    Posts
    191
    that is disturbingly hot.

  8. #18
    Insider PBSteve's Avatar
    Join Date
    May 2012
    Location
    Los Angeles
    Posts
    3,084
    Well... this looks promising.
    Ever so many citizens of this republic think they ought to believe that the Universe is a monarchy, and therefore they are always at odds with the republic. -Alan Watts

    I work for the company building the Paragon

  9. #19
    Insider
    Join Date
    Apr 2013
    Location
    Finland
    Posts
    174
    Pre order from here. http://www.automags.org/forums/showt...7-LPR-Foregrip

    Wink, wink, nudge, nudge.

  10. #20
    Insider FirePro84's Avatar
    Join Date
    May 2012
    Location
    Vacaville, CA
    Posts
    544
    Supports Inception Designs
    Oooooo...interesting, If I liked mags I would be all over that....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •