Results 1 to 2 of 2

Thread: Nummech VL Axe Frame Issue

  1. #1
    Hebrews 13:8 going_home's Avatar
    Join Date
    May 2013
    Location
    Florida
    Posts
    563

    Exclamation Nummech VL Axe Frame Issue

    I did email Nummech today about this issue FYI but just wanted to know if anyone else has experienced this.

    I cannot get this frame to work at all no matter what I do.

    Its like the bottom transfer tube (thats built into the frame itself) doesnt have a big enough inside diameter.

    Does nothing but shear the top transfer tube bottom (1x12mm) o ring no matter what I do.

    After several sheared o rings the stock frame went back on and everything is beautiful.

    Is there a known ID issue on the bottom transfer tube on this frame ?


    endeavor to persevere.......

  2. #2
    Hebrews 13:8 going_home's Avatar
    Join Date
    May 2013
    Location
    Florida
    Posts
    563
    Not sure the outcome of that frame issue.

    I sent it in to Nummech and they sent me a new one, works like a champ, no issues.

    EDIT: turns out the lower transfer tube inside diameter was too small as I suspected, but I give a thumbs up to their customer service !

    Last edited by going_home; 10-05-2014 at 09:20 PM.
    endeavor to persevere.......

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •