Anybody able to double check/verify (Jack) the threading between the valve guide and the valve joiner in an Etha for me? I'm getting 22.6mm OD, 1mm thread pitch.
Thanks
Printable View
Anybody able to double check/verify (Jack) the threading between the valve guide and the valve joiner in an Etha for me? I'm getting 22.6mm OD, 1mm thread pitch.
Thanks
Dunno what the official specs are supposed to be, but mine's reading at 22.75mm OD, .95mm pitch. I was just eyeballing the pitch though, so it's most likely not accurate.
Thanks Andrew.
Closed bolt, mech etha? (Mech etha = xvr)
+ Phenom/TiPXQuote:
Originally Posted by ironyusa
At least prototypes of both, not sure if we'll end up actually making either as a product.Quote:
Originally Posted by ironyusa
(looks for the 'Like' button)Quote:
At least prototypes of both, not sure if we'll end up actually making either as a product.
Ditto. :tup:Quote:
Originally Posted by pbjosh
I'd really like to see you close-bolt it and keep it elecro. That'd be sweet.
Keeping it an electro would be a good testbed for a universal board to let it work with eyes.
Hmm... you're right. I forgot about the electronics themselves.
Sorry, only just seen this. My Inception shortcut takes me straight to the Insiders forum, so I hardly ever look in here.Quote:
Originally Posted by y0da900
If it's still of any use, it should be 23mm with 1mm pitch.
Definitly quicker to just email me direct if you need any dimensions. jack.w@planeteclipse.com
Jack
Thanks for the verification Jack, I greatly appreciate it.
Jonathan