Inception Design 3-Way leak on a 2K Autococker
Just purchased a new Inception design 3-Way and installed it on my Autococker (old block with right-hand feed, might be a 1999 or 2000). Adjusted the LPR until it cycled correctly but not too much pressure. The firing and cycling settings a very close together, but function well. On the inception 3-way there is a little pilot hole next to the front barb (the one nearest the front block) and there is air leaking out of this hole. I believe it may have to do with where my actuator rod is set (using a hing frame). Should I be backing out the actuator rod (counter clockwise) or screwing it in further (clockwise)?
Very much want to eliminate the leak. Otherwise the gun is firing well. Can't wait to put some paint through it!