-
warpless z2
Ok so I was bored and decided I should hack up a loader :what:
http://i1065.photobucket.com/albums/...psbe82c027.jpg
Damn compared to the halo line the z2 has no room for this. Cut down the elbow and had to thin it down a little more than half of the material to get it to sit in the existing Raceway as I wanted to cut the z2 as little as possible.
http://i1065.photobucket.com/albums/...ps7a28a924.jpg
Had to notch the battery block to get it to fit will look into other power options later
http://i1065.photobucket.com/albums/...ps13129b4e.jpg
Almost there!
http://i1065.photobucket.com/albums/...psae50ece6.jpg
http://i1065.photobucket.com/albums/...psa598a44d.jpg
http://i1065.photobucket.com/albums/...pse7264316.jpg
Now I just need paint to test run in. Notice the motor is the same size as a halo one so might get some high torque motors depending on how the stock one holds up.
https://www.youtube.com/watch?v=IWhQ...e_gdata_player
-
-
-
Very cool. What's the capacity like with the tube going through the shell? I'll bet the 240 shells really helps with that.
-
Just put it on this morning so haven't gotten it out on the field yet but I don't think it would take to much out of the capacity.
-
On the z2 board is there a way to turn off the automatic un-jam feature?
-
On the latest board you can turn it down. I am not sure about off. You probably want to turn motor sensing off.
-
Yeah I just did that and swapped the motor for a hi torque motor i vehicle use on my halo too. I noticed a drop in the feed rate and I think the anti jam burned out the stock one
-
The Prophecy board uses feedback from the motor current to control it. Swapping out the motor have have caused the issue. It wouldn't be sensing it correctly.