Dont have a gopro handy but... Hmmm... i think I have something next door
What material is it printed out of and if you don't mind me asking, approximate cost and who you went through.
It looks really nice. Be cool to see something mounted on it.
Dont have a gopro handy but... Hmmm... i think I have something next door
Lmao. That would be fun to troll people with.
I used sculpteo... its in France.
I used them for a personal experiment with my BT4's... trying to convert them to a reliable .50 cal that was easier than the available options...
I got a working proto type but, i could only get it to shoot hard .50 cal paint... couldnt get the kee splatmaster stuff to shoot without exploding...
If it would put less pop on the ball.. i think it would have worked without gutting the internals.
I just used plastic as it was harder than resin... total cost was about $40 including shipping from France.
Last edited by YOUNGSTOWN; 10-16-2014 at 08:05 PM.
Now see.. all i need is a very short front made to fit the ergonomics...along with a remote line and a tactical body axe set to full auto... spray and prey time for sure..lol
EMR, Skirmish, Hell Survivors.. yeah, I'd rock that all day long.
On another note: I had a idea that I kinda thought of today to make drop in mag feed kit w/ adapter for the axe... I think that I'll do some sketches over the weekend to see if I can work out the finer points before I get to far in it...If the mechanics are there.. I think it would be a kick ass option for the growing mag feed community.
It's up on our social media.
Print one out. Should hold up ok side there won't be tons of force on it.
15/16-20 threads on both ends of the backs
Length of the unthreaded portion of the back is 47.75mm. Verify with what you have, but should be correct (got it from Simon).
So 15/16-20 to a 7/8-20 thread adapter. Not too terrible. I may have time this weekend to whip to a design too. Probably end up being about 3" long plus the tip. would only add about 1"or so to the back length.
Last edited by skibbo; 10-17-2014 at 12:18 PM.
It should be very possible and very well supported as it would sleeve over the back of the barrel...