-
Low pressure regulator valve seals
http://palmer-pursuit.com/cart/valve...g5i8k8j8fj97d0
Anyone know what material these seals are made out of? Where to aquire it?
-
Insider
They're usually 90-duro urethane or any other such elastomer. To make them you need a couple of punches in the right sizes (don't have my spares or calipers with me right now, so I can't say what size those are) and sheets of the preferred material.
-
I have one I can measure, thanks.
I did a search and all I could find in small quantities for 1/16" was through MSC, I hate shopping there with their inflated prices, any idea where I can find this in a small quantity? I need to make about 50.
-
Insider
McMaster has 90-duro black polyurethane sheets 1/16" thick, 6" X 20' at $9.00 + shipping. Couldn't find any less quantity for less $. The good thing is, most reg seats are made of it, even for moving base regulators; so if you get the right set of punches, you can sell the rest as spare seats, I know some users at automag owners or custom cockers would love some for their older discontinued regs (air america, sheridan, etc).
-
Damn, I searched at McMaster-Carr and nothing came up, I'll have to look again.
-
I think I found it, is this the part number you're referring to?
2178T23
-
Insider
-
Thanks for all the help, much appreciated.
I'll have to pick up a press and figure out where to get the dies.
-
Insider
-
There is a little more to it than that.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules