-
Insider
Round Body Merlin CAD file (solidworks)
Since I was taught to share by parents I have something to share with the creative minds here. Its a round body merlin that I made in solidworks. I also saved it as a parasolid (x.t). I pulled all dimensions from a Break Beam prototype I bought off Aaron Alexander (AKA). I have left a few things off of it. I have made several fumctional merlins from the files below, but use at your own risk.
http://www.karadan-kreations.com/photos/Misc./CAD/
The two files in the link above:
RAW round body merlin.SLDPRT
RAW round body merlin.x_t
Simon, feel free to host them on here if you like.
Last edited by evil_racecocker; 06-23-2012 at 10:38 PM.
-
Insider
-
Insider
I run two vises with two fixtures in each currently. Here is my old fixture:
My new one is very similar but uses pins that locate in the hammer lug pocket and ASA air holes. With bolts using the Valve set screw, and two frame screws. I have a design for a better fixture I want to do down the road. It will have a manifold that bolts onto the body, the manifold then bolts onto a universal block. The mainfolds would all have the same locating pin hols and bolt patterns when bolting onto the universal block, but a different manifold for a different type of gun. Like the viking and excalibur i'm working on.
-
Insider
Nice. I am working on my universal system right now. I'll have a base plate mounted to the 5 axis platter, then a block that mounts to it for the bottom of the gun body and blocks with pins that slide into the main bores from each end. I'll post up pictures once I get them sorted out. The gun body blocks could then also be removed and a fixture for frames located onto the base plate etc.
-
How can I get the round body merlin files now?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules