Results 1 to 4 of 4

Thread: Identifying Threads on a Bolt

  1. #1

    Identifying Threads on a Bolt

    Can anyone direct me to a guide or a good youtube video that teaches you how to identify threads? I am having trouble finding a universal process.

    Thanks!

  2. #2
    Insider
    Join Date
    Feb 2014
    Posts
    1,578
    I use a caliper on the major and one of these and am usually pretty close:

    http://www.amazon.com/Grip-Thread-Pi.../dp/B004ROIU2A

    Most of what you're doing with the slambolt is threaded based on your call-out, so as long as that matches you are fine. The rear thread on the matrix is fairly coarse, so you probably have a little slop.

    This thread has also been helpful to me in the past:

    http://www.pbnation.com/showthread.php?t=803907

  3. #3
    Insider new ion?'s Avatar
    Join Date
    Feb 2013
    Location
    Victoria, BC
    Posts
    1,251
    Supports Inception Designs
    I think this will help too: http://www.shender4.com/thread_chart.htm

  4. #4
    Insider PBSteve's Avatar
    Join Date
    May 2012
    Location
    Los Angeles
    Posts
    2,757
    You need 2 things to identify a straight external UN thread. Major diameter and thread pitch. For fine threads found in paintball the major diameter can just be taken from the outside of the bolt using the wide portion of the calipers.

    The incorrect way to measure pitch that I use all the time is along these lines (using calipers):



    You have to be careful to measure from and to the same "part" of the thread. In the image above it's the right side of the crest to the right side of the crest. The more threads you can get the more accurate this will be, although if you're counting more than say... a half inch of threads you're probably going overboard.

    The shender4 website new ion? linked is good, and it's where I started, but efunda is a bit more technical - or if you plan on doing a bit of this work, the machinists handbook is a good reference to just have. An older used version (read:cheaper) would be fine, since the simpler operations we do for paintball don't change much.

    http://www.efunda.com/designstandard...rt=1&finish=63
    Last edited by PBSteve; 04-21-2015 at 10:55 PM.
    A Radiant Purple Sky Ribbon That Defies Explanation
    I work for the company building the Paragon...once we figure out a name

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •