Results 1 to 2 of 2

Thread: UFC "Ultra Flow and Clearance" Three way

  1. #1

    UFC "Ultra Flow and Clearance" Three way



    The UFC (Ultimate Flow and Clearance) is the latest, most modern three way on the market. It has all of the greatest features combined into the smallest package possible so that it will fit on front blocks even with the largest LPR's.

    The Ultimate FLow and Clearance "UFC" three way has the following features.

    * Minimalistic "FLE" body. All excess material is machined away. This makes it very narrow on the sides giving the most clearance for installation and cleaning (also makes it lighter because we all know that will make no difference to your game as it's less than a paintball's weight...)

    * Standard 1mm by 3mm o-rings for faster switching and to make replacement easy with standard o-rings available anywhere.

    * Bell curved flow paths on the stem between o-rings for the best air flow from one barb location to the other. This also makes the stem stronger and less likely to get bent.

    * Counter bored exhaust holes - allow faster flow of the vented air, making for a faster pneumatic switching system (a similar goal to QEV's but implemented at the three way).



    * Easy micro adjustment via the 5/64 allen key hole in the front. Allows for the perfect setting of your time and makes adjustment for the shortest pull super easy and quick to do.

    * Easy build design. When building the gun you initially adjust the front of the three way stem to be flush with the front of the three way and the gun will air up correctly and be very close to the correct timing. Then you can tweak it in easily via the allen key as you time your trigger.



    * 5-40 threaded stem allows for fine adjustment. Comes with two nylon locking set screws (6-32) to create tension on the timing rod and to prevent the timing from ever moving but still allowing easy adjustment when needed.

    5-40 timing rods in many different lengths (Minicocker, Resurrection, WGP full body and Extended reach lengths are all available from Inception Designs.

    When installing on a frame with a slide trigger the rear barb connects to the rear of the ram (where it screws into the front block) and the front barb connects to the front of the ram (near the end you point at your opposition).

    When installing on a hinge frame, you need to swap the front and rear hoses so that the rear barb on the three way connects to the front of the ram, and the front barb on the three way connects to the rear of the ram).

    Available now from your favourite Inception Designs Dealer.

  2. #2
    We now have a pretty image showing how to set up the hoses with our three-way depending on what frame you are using it with Click the image to make it larger.



    The dotted line at the bottom shows where the middle o-ring should align for the frame at rest. This means that with a slide frame the adjuster end of the stem is flush with the valve body. With a hinge frame it will be set inside the end of the valve body.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •