Are these going to be Solidworks format, or .IGS? I have the .IGS parts if those would help.
I started to dredge this out again but the upload limit is very small (<1MB) and the files total 28MB. I'll shoot Simon and e-mail shortly and see if he can take care of it.
Are these going to be Solidworks format, or .IGS? I have the .IGS parts if those would help.
You have them hosted for download? That would help. I dare not edit my original post here because doing so to my introduction thread caused it to disappear for some reason.
Did you make them or are they the ones that I hosted through MCB? I've emailed Simon with my .sldprt files, just waiting on a reply.
Last edited by Siress; 04-23-2012 at 12:46 PM. Reason: adf