Results 1 to 2 of 2

Thread: 3-way threading on mini front blocks

  1. #1
    Junior Member
    Join Date
    Jun 2018
    Posts
    2

    3-way threading on mini front blocks

    I have an Inception Designs mini front block that I got with the extended reach kit. The 3-ways and EBlade solenoid that I tried to screw into it don't fit. They go in a thread and stop. Is the threading on the front block for the 3-way different than WGP standard?

  2. #2
    It should be the same threads. Check the threads on the front block and make sure they are clean and unobstructed. There might be a problem with the threads. If you have a tap set, with that thread aize, you can also chase the threads, or just contact Inception Designs customer service.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •