Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: New ID (SAS and NOS) trigger plates?

  1. #11
    Quote Originally Posted by SC_Thumper View Post
    I installed the new plate in a ressy frame last week. Got to play today at the local field. All the choppy feel is now gone. In my setup I had to run the lug on the hammer deeper than I would like but it was the only way I could get it to reset consistently. My hammer now falls about mid trigger pull. Overall I am mostly happy. I have the inception hammer, springs, valve, and now trigger plate. The only thing left is the sear. I am not really sure if that will change any of the geometry of the hammer release or not. For sure this is nice and smooth now.
    Good to know.

    Which one did you get? The NOS or the SAS?

  2. #12
    Junior Member
    Join Date
    Apr 2018
    Location
    Greenville SC
    Posts
    9
    Quote Originally Posted by Menace View Post
    Good to know.

    Which one did you get? The NOS or the SAS?
    I purchased the NOS kit. I put in the stiffest return spring and the stiffest sear spring. It is quite smooth with no binding at all. I played with a few combinations but I always got hammer skip. I had to go deeper with the lug to get it to reset consistently. It seems ok now but now I am questioning if the PO of this ressy messed with the sear. There are too many home airsmiths in the wold.

  3. #13
    Aside from the aesthetic differences in pull feel, would you go so far as to say that, in terms of actual ROF, the trigger is now faster, or about the same?

  4. #14
    Junior Member
    Join Date
    Apr 2018
    Location
    Greenville SC
    Posts
    9
    Quote Originally Posted by Menace View Post
    Aside from the aesthetic differences in pull feel, would you go so far as to say that, in terms of actual ROF, the trigger is now faster, or about the same?
    ROF? Not really what I was after. I would think it should be a little better but I am much faster with a hinge when it comes down to it. I was after making this feel more like a traditional cocker. The stock ressy pull just feels weird to me.
    update: Put another case and 1/2 through it today. Finally got this where I want it timing wise. I would say it is a keeper as far as upgrade goes.
    Last edited by SC_Thumper; 10-13-2018 at 04:01 PM.

  5. #15
    Good to know, thanks!

    So how did you end up setting it up in terms of timing?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •