Dumb question:
Can this system be hacked into a warp feed?
How to install a Empire RF Transmitter Link Kit in the Prophecy Z2 loader
1) The loader should be turned off
2) Remove the Prophecy Z2 loader backplate
3) There is a 6 pin connector on the rear of the Prophecy Z2 circuit board opposite of the on off switch. Use the appropriate harness from the Empire RF Transmitter Link Kit and plug it into the 6 pin connector. The harness should be oriented such that there are 2 wires on top and 1 wire on bottom.
4) Plug the female 3 pin side of the harness into the Empire RF Transmitter.
The link kit is now installed.
How to Synchronize Prophecy Z2 loader to marker
To use the Loader in RF mode, an Empire RF Transmitter must be installed in your marker and in your Prophecy Z2 loader.
1) Make sure your marker is degassed and unloaded.
2) Turn your marker on and if your marker has eyes turn them off so you can cycle the solenoid. Read your marker’s manual for eye operation if you are having problems turning them off.
3) Remove the Prophecy Z2 loader backplate and turn on the loader.
4) Press and hold FORWARD button until both the red and green LED are on (3-5 seconds).
5) Release the forward button while the green and red LED’s are lit, pull the trigger on your marker. This must be done within 2 seconds of both LEDs being on.
6) If done correctly and a signal is received by the loader the red LED will turn off and the green LED will remain on.
You are now ready to use your Prophecy Loader in RF Mode. The loader will stay synched with your marker even after you turn both the loader and marker off. You do not need to re-sync the loader and the marker each time they are turned on.
Dumb question:
Can this system be hacked into a warp feed?