My CAD work - Willing to take requests!

[General Cole]

Sorry to resurrect this from out of nowhere, but I'm interested in your Etha bolt in terms of the CAD. Anyway I could snag a copy of a the part itself? A simple parts sheet would suffice with dimensions. I'm in the middle of a side project and could use the help of the design so I don't have to go buy one.... And great looking work, the attention to detail on the feedneck is amazing!

[BTAutoMag]

i minght have a fun mag project for you as well, ill pm you

[skibbo]

Sorry to resurrect this from out of nowhere, but I'm interested in your Etha bolt in terms of the CAD. Anyway I could snag a copy of a the part itself? A simple parts sheet would suffice with dimensions. I'm in the middle of a side project and could use the help of the design so I don't have to go buy one.... And great looking work, the attention to detail on the feedneck is amazing!

I can put up the file. Just give me a little bit. Should have it up by the end of the night.

i minght have a fun mag project for you as well, ill pm you

Sounds like a plan.

[skibbo]

Sorry to resurrect this from out of nowhere, but I'm interested in your Etha bolt in terms of the CAD. Anyway I could snag a copy of a the part itself? A simple parts sheet would suffice with dimensions. I'm in the middle of a side project and could use the help of the design so I don't have to go buy one.... And great looking work, the attention to detail on the feedneck is amazing!

Got it done, not sure how right it is, I only measured once so take that into consideration.