Results 1 to 2 of 2

Thread: Bob Long feedneck dimensions

  1. #1

    Bob Long feedneck dimensions

    So, I think the feedneck on my Clone's about to go and I'm looking for a replacement, but found that the new Empire feedneck probably won't fit well because of the shape and size (http://simonized.com/showthread.php?...eck-dimensions).

    Does anyone know if a Bob Long feedneck will fit on a Clone? Or does anybody know the OD of the feedtube that protrudes from the body of a G6R/Vic/Insight?

  2. #2
    Insider FirePro84's Avatar
    Join Date
    May 2012
    Location
    Vacaville, CA
    Posts
    544
    Supports Inception Designs
    If you haven't found the answer to this yet, I just took a neck off my VCOM and tried it on my GT. The BL neck was very loose when I first put it on, but you can tighten it down to hold ok. The main difference I see with the two is that with the BL neck on the GT body the GT feedneck post actually sticks up higher than the bottom lip inside the BL neck.

    The wide point on the GT neck post is .900" and the wide point on the BL neck post is .950"

    final opinion, you can make it work, but I'm not sure how sturdy it's going to be.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •