-
Insider
I minght be beating a horse around here but if youre designing a body kit for the 303 why not take it a step further and just design a shell that will take a regular automag valve and a 303 mag?
your market then moves out of just the 303 owners and anyone can put one together that has a spare valve laying around.
(also make the FPS adjustable without taking the gun apart)
-
Insider
Its a thought. A good one. But first comes modifiying the FN's we have. Its a personal project at this point.
-
Insider
not hard, I've cut open a valve before if you want me to do it
-
Insider
It's not hard, you just need to be careful where you cut, and how much you cut...
-
Insider
I just dont know the size of the spacers you need to insert to get it down to the correct volume.
-
Insider
Lots. It was way more than I expected.
The chamber seems almost full... but the result has been amazing and is extremely consistent so I am not messing with anything
-
Insider
cna you post specs on what's in yours? I have one I'm converting for a friend. I was going to trial and error it until I could get it to chrono correctly but if I can get it on the first try that would be GREAT!
-
Insider
I just made spacers to fit the internal bore, with a hole down the middle, and then in 0.5, 0.25, and 0.1" lengths and then put them in until velocity was correct. That will depend on your barrel etc. too. I put in way more than I expected, so I would probably fill the chamber 75% and then work from there. It's been a long time since I did it so I don't recall the inside hole diameter
-
Insider
ok, if you happen to have it apart measure it for me. but its a good place to start
-
Might have already seen this, but here's pretty good step by step with pictures.
http://www.mcarterbrown.com/forums/d...paintball.html
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules